Remodela Holics

Your Vision, Our Expertise.


Troubleshooting Car Wont Start Just Clicks and You Hear a Sound

As a car owner, we’ve all experienced those frustrating moments when our beloved vehicle refuses to Car wont start just clicks. You turn the key, but all you hear is a clicking sound. This is a common occurrence that can have various causes. In this article, we will delve into the possible reasons behind this issue and explore potential solutions.

Understanding the Clicking Sound

When your car won’t start and you hear a clicking sound, it usually indicates that there is a problem with the electrical system. More specifically, the clicking sound originates from the starter motor relay or solenoid trying to engage the starter. This repetitive clicking noise is often due to a lack of sufficient electrical power reaching the starter.

Possible Causes of the Clicking Sound

  1. Weak or Dead Battery: One of the most common culprits behind a clicking sound is a weak or dead battery. A battery that doesn’t have enough charge cannot provide the necessary electrical power to crank the engine. This can be caused by leaving the lights on overnight or a faulty charging system.
  2. Corroded Battery Terminals: Corrosion on the battery terminals can be another reason for the clicking sound. Over time, the terminals can accumulate rust and grime, obstructing proper electrical flow. This can hinder the transfer of power from the battery to the starter motor.
  3. Faulty Starter Motor: A defective starter motor can also contribute to the clicking sound. The starter motor consists of various parts, such as brushes and gears, which can wear out over time. If these components are damaged or worn, the starter motor may fail to function properly, resulting in a clicking sound.
  4. Damaged Ignition Switch: The ignition switch is responsible for initiating the start sequence when the key is turned. A faulty ignition switch can disrupt the flow of electricity and prevent the starter motor from engaging. This can lead to the clicking sound without the engine starting.

Troubleshooting Steps

  1. Check the Battery: Start by checking the battery voltage using a multimeter. A healthy battery should typically register around 12.6 volts. If the reading is significantly lower, recharging or replacing the battery may be required. Ensure that the battery terminals are clean and free from corrosion.
  2. Inspect the Starter Motor: If the battery tests positive, the next step is to inspect the starter motor. Locate the starter motor, often located near the engine or transmission. Tap on it gently with a mallet while someone tries to start the car. If the vehicle starts, it indicates a faulty starter motor that requires replacement.
  3. Verify the Ignition Switch: If the previous steps have not resolved the issue, the ignition switch may be the culprit. Consult the vehicle’s manual or seek professional assistance to inspect and possibly replace the ignition switch.
  4. Other Considerations: In some cases, the clicking sound can be caused by a faulty solenoid or damaged wiring. These scenarios may require more advanced troubleshooting and professional expertise to resolve.

Experiencing a clicking sound when your car won’t start can be frustrating, but understanding the potential causes helps in troubleshooting the issue. Weak batteries, corroded terminals, faulty starter motors, or damaged ignition switches can all contribute to this problem. By following the troubleshooting steps mentioned above, you can diagnose and address the issue effectively. However, if you are unsure or uncomfortable with these tasks, it is always advisable to consult a professional mechanic to ensure the proper resolution of the problem.